Conair FC-33 Guia do Utilizador descarregar pdf (Página 11)

UGG003/0398 CF Series Granulators

INSTALLATION 7

5. Installation

Read through the whole of chapter 5 before installing the machine! All instructions

must be followed in the given order to avoid injury or damage.

Be careful with the knives, they are sharp and can cause personal injury.

The granulator must only be connected to the mains by a competent electrician.

5.1 Pre-start checks

¥ The unpainted parts of the machine are protected with oil prior to delivery and

transport Clean the granulator from rust protection agent before it is used.

¥ Check the knife clearance and tightening torque on the bolts for the knives. Refer

to installation of knives in chapter 7.

5.1.1 Two hours after first start

Check the knife clearance again and the tightening torque of the knife retentio

screws. Check the screws for both the fixed and rotating knives.

5.2 Electrical connection

The granulator should be connected by a competent electrician.

¥ Connect the granulator to the main power supply. The wiring diagram indicates

the fuse sizes, see chapter 9.

¥ The granulator is delivered with electrical equipment connected for clock-wise

phase rotation. Check with a phase sequence indicator and connect the granulator

with clockwise phase rotation.

Check the direction of rotation of the granulator motor:

¥ Make sure that the main switch beneath the control panel is ÒOnÓ (1).

¥ Check that the emergency stop is not activated.

¥ Check that the star knobs on the hopper and screen box locks are fully tightened

to stop.

¥ Undo and remove the upper panel on the right hand side of the granulator.

¥ Press ÒStartÓ

¥ Check that the granulator motor rotates in the direction indicated by the arrow on

the cutter pulley.

¥ Granulator with blower, Ð check that the direction of rotation of the blower corre-

sponds with the arrow on the cover.

NOTE! The blower blows even if the direction of rotation is wrong.

¥ Granulator with conveyor belt, Ð check the direction of the conveyor belt.

If any direction of rotation should be incorrect:

¥ Press the stop button.

¥ Switch off the main switch.

¥ Switch two incoming phases.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 57 58

Sem comentários

Conair FC-33 Guia do Utilizador Página 11