Conair FC-33 Guia do Utilizador descarregar pdf (Página 18)

CF Series Granulators UGG003/0398

14 SERVICE

7. Service

All service must be carried out by trained personnel in order to avoid personal

injury or damage to the machine.

7.1 Changing knives

Removing the knives

Check the screen for wear when the knives are changed. Change the screen

when the holes begin to be pear shaped.

Be careful when handling the knives, they are sharp and can cause perso-

nal injury. Use protective gloves!

Each time the knives are changed, the knife fastening screws must be

replaced by new ones.

Changing the knives.

Open the hopper and any door. Remove the granule bin, then fold the screen

box down and lift it out Ð see chapter 5.3.

Removing the rotating knives.

1. Remove the screws (A) and washers (B),

2 each per knife. The knives are now loose.

2. Lift out the rotating knives.

3. Clean the surfaces where the knives were

located.

Removing the fixed knives.

4. Undo the socket cap screws (C) on the

front knife support rule (D).

5. NOTE! Hold the fixed knife and support

rule before removing the last screw.

6. Lift out the fixed knife together with the

support rule.

7. Clean the knife location.

8. Put the support rule back loosely.

9. Undo and remove the socket cap screws

(E) on the rear knife support rule (F).

10. NOTE! Hold the fixed knife and support

rule before removing the last screw.

11. Lift out the fixed knife together with the

support rule.

12. Clean the knife location.

13. Put the support rule back loosely.

A, B

E F D C

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Sem comentários

Conair FC-33 Guia do Utilizador Página 18